The following tables list pin descriptions of the sensor connectors. All 3.3V UART and 3.3V I2C interfaces are not 5V tolerant. For additional detail on sensor interfaces contact Sentera Support.
The sensor can auto-negotiate the Ethernet speed. Therefore, only four pins are required for a slower 10Base-T or 100Base-T speeds. All eight pins are required for communication at a 1000Base-T speed. Depending on your host platform, your power connection method may vary.
Onboard Connector
JST
GH
BM06B-GHS-TBT
Mating Connector
JST
GH
GHR-06V-S
Onboard Connector
JST
GH
BM10B-GHS-TBT
Mating Connector
JST
GH
GHR-10V-S
Onboard Connector
JST
GH
BM08B-GHS-TBT
Mating Connector
JST
GH
GHR-08V-S
Power Distribution (PD)
No
USB3.1
Yes
Onboard Connector
Same Sky
PJ-044AH
Mating Connector
Same Sky
PP3-002A
Sleeve: GND
Pin: VCC
eXFAT Support
No
UHS-I
Yes
UHS-II and above
No
SD Express
No