Sentera offers a kit for mounting 65R with a DJI XT30 connector for use with 6X gimbals with Skyport mounting hardware.

The input voltage range is 12-16VDC and the typical power draw is 20 watts.

Kit Contents

SKU: 21229-00

• Gimbal Interconnect

• Vibration Dampeners

• Power Cable

Sentera XT30 Mounting Plate

The kit can be attached to the air vehicle using the mounting hole pattern shown.

Introduction

The 65R gimbal supports several interface options for mounting and connecting to an aircraft.

Smart Dovetail

Gremsy HDMI Hyper Quick

DJI XT30/Skyport

The 65R gimbal with the HDMI Hyper Quick mounting configuration can be used with the Gremsy Hyper Quick receiver.

Serial Connection

For HDMI Hyper Quick configurations the serial lines are connected the TX2/RX2 lines on the Gremsy receiver.

Pinout Table

Example Cable

Ethernet Connection & PPS

The ethernet lines from the gimbal are connected to AUX S1, S2, S3, S4 on the Gremsy receiver. AUX S5 is connected to PPS.

Pinout Table

Example Cable

Mechanical Connection

Where to Purchase

Mounting Specifications

The 65R gimbal with the Smart Dovetail mounting configuration can be used with Smart Dovetail equipped aircraft.

Connection I/0

The 65R has Serial, Ethernet, and PPS I/O available on Smart Dovetail hardware.

See further information here:

Mounting Specs

The mounting patterns can be found here: