Current Astro firmware and 65R firmware requires two parameters to be set for seamless operation. This requirement will be removed in an upcoming firmware release. Please use the page linked below for instructions on how to set the parameters.
Power on Astro and hand controller & Connect
Open AMC
Enter advanced mode by rapidly tap on the Auterion logo in the upper left hand corner until a dialog box appears.
Press Switch to Advanced
Press the Auterion logo in the upper left hand corner and press Advanced
Scroll down to Parameters on the left hand menu
In the search bar search "baud"
Change SER_EXT2_BAUD to 115200 8N1 and press Save
In the search bar search "MAV"
Change the MAV_MODE from GIMBAL to Normal and press Save
Turn the aircraft off
Connect the sensor to the aircraft
Power on aircraft
Restart AMC
Verify the lights on the sensor turn solid green