Ctrlk
Home PageCreate a Ticket
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Offload Process

Getting Started

The 65R stores the imagery on an internal solid state hard drive that is not removable from the sensor. Use the process outline below to access the collected data.

Imagery is NOT stored on the micro SD card.

Instructions

1

Power On Sensor

Power the 65R using the AC adapter or keep it attached to the aircraft and turn the aircraft on.

Then wait for the LEDS on the sensor to do the following:

Power Method
LED Behavior

AC Power Adapter

Flashing Red

Drone Power

Solid Green (Requires GPS Fix) Solid Red (After 2 minutes w/o GPS)

This verifies that the sensor is fully booted and ready for data offload.

2

Connect USB Cable to Sensor and Computer

Connect the sensor to the computer using a USB cable.

Use the USB-C port on the sensor not the USB-C port on the top of the gimbal.

Use the USB-C Cable provided with the 65R. This cable gives the best and most reliable performance.

3

Open a File Browser Window

4

Navigate to Sensor Storage

Navigate to the 65R internal storage by typing \\192.168.42.1 into the address bar of the file browser and pressing enter.

\\192.168.42.1

Backslashes are required to navigate to the sensor internal storage. Ensure that you type \\ before the sensor IP address.

The sensor may need a minute to fully boot before it can be accessed via the file browser.

If the 65R can't be connected to after a few minutes try the following: - Turn off/disconnect any Wi-Fi or Ethernet connections that have internet access. - Verify the USB cable being used is the provided cable or one of the listed compatible cables

Adding this file path to Quick Access can be helpful for repeated use.

5

Login to Sensor

Windows will display a network credentials pop-up. The user name is sentera and there is no password. Press OK.

If your user account is controlled by a domain .\sentera may need to be used as the username. If this does not work please see link below on how to resolve issue.

Connecting With Domain Controlled Accounts
6

Select Data Folder

7

Select Snapshots Folder

8

Select Session Folder

Session folders are the folders where the imagery is stored for each flight.

If the 65R is not power cycled between flights that are intended to be separate (i.e. not a battery swap) all of the photos from both flights will be stored in the same session folder.

9

Copy Folder

Ensure that you always copy-paste (ctrl+C) and not cut-paste (ctrl+X). Using cut-paste can lead to data loss that cannot be undone.

PreviousEquipment
NextOffload Process - Mac

Last updated