How To Update

Download Firmware Update File

Latest Version

Before You Start

Data will be deleted during the firmware upgrade process. Make sure to copy the data off your sensor before performing the update.

This Process works on Windows or Mac.

Power On Sensor

Power the 65R using the AC adapters or keep it attached to the aircraft and turn the aircraft on.

Then wait for the LEDS on the sensor to do the following:

Power Method	LED Behavior
AC Power Adapter	Flashing Red
Drone Power	Solid Green (Requires GPS Fix) Solid Red (After 2 minutes w/o GPS)

This verifies that the sensor is fully booted.

Connect Sensor to Computer

Connect the sensor to the computer using a USB cable.

Use the USB-C port on the sensor not the USB-C port on the top of the gimbal.

Use the USB-C Cable provided with the 65R. This cable gives the best and most reliable performance.

Verify Connection

Open your wifi/network panel from the task bar. Verify that you see "unidentified network - No internet". This is the 65R appearing as a network device.

Open Sensor Webpage

In a web browser (no internet required) type 192.168.42.1 into the address bar and press enter.

How To Access Web User Interface

If the sensor is being powered by the AC adapter the screen will appear red with a warning message.

Select Update Firmware

Apply Firmware File

Allow Update to Execute

The software update process begins and may take several minutes. Do not turn off the power or disconnect the cable during this process. It may reboot several times during the process.

Allow Sensor to Self-Reboot

Complete

Once complete, the web page will refresh. You can check the firmware version after the web page refreshes by checking the 'Current Version' at the top of the update page, or the version in the lower left of the web page menu bar.