DJI M400

6X Series Sensors Installation - DJI M400

Before you begin

The 6X Sensor requires stand alone mode for use with the M400. In this mode the 6X uses GPS data from the light sensor/GPS module to determine when it should trigger the camera.

View the links below to learn about the Standard Operating Procedures for stand alone mode, and how to change overlap settings.

Stand Alone Mode (External GPS)How To Change Overlap Settings

---

6X & Light Sensor

Instructions

1. Install light sensor/GPS into mounting tray.
2. Connect USB-C cable into light sensor.
3. Secure USB-C Cable in both cable clips.
4. Install 6X gimbal into Skyport.
5. Connect USB-C cable to gimbal.
6. Power On the aircraft.

The light sensor is connected to the USB-C port on the upper portion of the gimbal not the USB-C port on the sensor itself.

If a light sensor is not bring used, simply omit the related steps.

---

Light Sensor/GPS Mounting

If a Light Sensor/GPS was purchased with the 6X, the hardware to mount to the drone needs to be installed. See the instructions linked below.

DJI M400

---

Adding 6X to DJI Pilot

Adding 6X Sensors to DJI Pilot

---