Astro

6X Series Sensors Installation - Freefly Astro

6X & Light Sensor

Compatibility Instructions

Current Astro firmware and 6X firmware requires two parameters to be set for seamless operation. Please use the page linked below for instructions on how to set the parameters.

This requirement will be removed in an upcoming firmware release.

Freefly Compatibility Settings

---

Instructions

1. Install light sensor/GPS into mounting tray.

2. Install 6X gimbal into smart dovetail.

3. Secure smart dovetail latch.

4. Connect USB-C cable into light sensor.

5. Secure USB-C Cable.

6. Connect USB-C cable to gimbal.

7. Power On the aircraft.

The light sensor is connected to the USB-C port on the upper portion of the gimbal not the USB-C port on the sensor itself.

If a light sensor is not bring used, simply omit the related steps.

---

Light Sensor/GPS Mounting

If a Light Sensor/GPS was purchased with the 6X, the hardware to mount to the drone needs to be installed. See the instructions linked below.

Freefly Astro