How to Use

Before Starting

Reflectance Panel

If a reflectance panel is also being used see the page linked below:

Install Light Sensor/GPS

1. Install the light sensor and gimbal onto the aircraft.

2. Connect the USB-C cable to the light sensor.

3. Secure the cable to the aircraft.

4. Connect the USB-C cable to the port on the gimbal.

Power on Aircraft & Verify Status LEDs

1. Power on the aircraft. This will also power the gimbal, sensor, and light sensor on.

2. Verify the Status LEDs shown below have all turned solid green.

Fly

The sensor and light sensor are now ready for flight.