DJI XT30

6X Series Sensors Gimbal Connector Integrations - DJI XT30

Sentera offers a kit for mounting 6X with a DJI XT30 connector for use with 6X gimbals with Skyport mounting hardware.

The input voltage range is 12-16VDC and the typical power draw is 20 watts.

This mounting method only supports powering the 6X, gimbal, and light sensor/GPS. Triggering must be accomplished via stand alone mode.

DJI XT30 Receiver

6X - Skyport Interconnect

SKU: 21229-00

The kit can be attached to the air vehicle using the mounting hole pattern shown.

Last updated 8 months ago