6X Series Sensors How To Access The Webpage UI
Power the sensor using the AC power adapter or install into the aircraft and turn the aircraft on.
Then wait for the LEDS on the sensor to do the following:
AC Power Adapter
Flashing Red
Drone Power
Solid Green (Requires GPS Fix) Solid Red (After 2 minutes w/o GPS)
This verifies that the sensor is fully booted.
Connect the sensor to the computer using a USB cable.
Use the USB-C port on the side of the sensor not the USB-C port on the top of the gimbal.
Use the USB-C Cable provided with the 6X. This cable gives the best and most reliable performance.
Open your wifi/network panel from the task bar. Verify that you see "unidentified network - No internet". This is the 65R appearing as a network device.
Open a web browser (chrome, safari, firefox, etc).
No internet connection is required.
In the address bar enter 192.168.42.1 and press enter/go.
The webpage will appear.
If the webpage can't be connected to after a few minutes try the following: - Verify the sensor has had around a minute to boot. - Turn off/disconnect any Wi-Fi or Ethernet connections that have internet access. - Verify the USB cable being used is the provided cable or one of the listed compatible cables.
If the 6X is being powered with the AC power adapter, the No Gimbal Communication application will appear. This is expected as the gimbal itself is now powered.
