6X Series Sensors Gimbal Connector Integrations - DJI XT30
Sentera offers a kit for mounting 6X with a DJI XT30 connector for use with 6X gimbals with Skyport mounting hardware.
The input voltage range is 12-16VDC and the typical power draw is 20 watts.
This mounting method only supports powering the 6X, gimbal, and light sensor/GPS. Triggering must be accomplished via stand alone mode.
SKU: 21229-00
Gimbal Interconnect
Vibration Dampeners
Power Cable
The kit can be attached to the air vehicle using the mounting hole pattern shown.
6X Series Sensors Gimbal Connector Integrations - Gremsy T3/S1 Hyper Quick
The 6X gimbal with the T3/S1 mounting configuration can be used with the Gremsy T3 or S1 Hyper Quick receiver.
For T3/S1 configurations the serial lines are connected the TX2/RX2 lines on the Gremsy receiver.
2
TX2
3
RX2
6
GND
The ethernet lines from the gimbal are connected to AUX S1, S2, S3, S4 on the Gremsy receiver. AUX S5 is connected to PPS.
5
PPS
6
RX_N
7
RX_P
8
TX_N
9
TX_P
6X Series Sensors Gimbal Connector Integrations - Smart Dovetail
The 6X gimbal with the Smart Dovetail mounting configuration can be used with Smart Dovetail equipped aircraft.
The 6X has Serial and Ethernet I/O available on Smart Dovetail hardware.
2
PPS
4
Payload RX
6
Payload TX
7
VBAT
8
GND
9
RX_N
11
RX_P
13
VBAT
14
GND
15
TX_N
17
TX_P
See further information here:
Smart Dovetail interfaces can be purchased from Freefly.
The Mounting patterns can be found here:
Smart Dovetail Receiver
6X - Smart Dovetail Interconnect
DJI XT30 Receiver
6X - Skyport Interconnect
Gremsy HDMI Hyper Quick
6X - T3/S1 Interconnect
