6X Series Sensors - Incident Light Sensor Installation - IF1200A
Remove the two screws near the GPS on the right hand side (Nearest the A) as shown.
Install the mounting bracket as shown.
Use the provided screws to secure the bracket using the holes the original screws were removed from.
Install the first cable clip on the top side of the aircraft in the area shown.
Use the provided alcohol wipes to clean the surface of the drone before adhering the clip.
Install the second cable clip on the underside of the aircraft in the area shown.
Use the provided alcohol wipes to clean the surface of the drone before adhering the clip.
The mounting bracket does not need to be removed to be stored in the case, but the light sensor itself does need to be removed from the mounting tray.