6X Series Sensors Gimbal Connector Integrations - DJI XT30
Sentera offers a kit for mounting 6X with a DJI XT30 connector for use with 6X gimbals with Skyport mounting hardware.
The input voltage range is 12-16VDC and the typical power draw is 20 watts.
This mounting method only supports powering the 6X, gimbal, and light sensor/GPS. Triggering must be accomplished via stand alone mode.
SKU: 21229-00
Gimbal Interconnect
Vibration Dampeners
Power Cable
The kit can be attached to the air vehicle using the mounting hole pattern shown.
DJI XT30 Receiver
6X - Skyport Interconnect
