6X Series Sensors Firmware Update Instructions
Data will be deleted during the firmware upgrade process. Make sure to copy the data off your sensor before performing the update.
This Process works on Windows or Mac.
Power the 6X using the AC adapter or keep it attached to the aircraft and turn the aircraft on.
When using the AC power supply, connect the cable to the 6X first, then connect the adapter to the outlet.
Then wait for the LEDS on the sensor to do the following:
AC Power Adapter
Flashing Red
Drone Power
Solid Green (Requires GPS Fix)
Solid Red (After 2 minutes w/o GPS)
This verifies that the sensor is fully booted.
Connect the sensor to the computer using a USB cable.
Use the USB-C port on the sensor not the USB-C port on the top of the gimbal.
Use the USB-C Cable provided with the 6X. This cable gives the best and most reliable performance.
Open your wifi/network panel from the task bar. Verify that you see "unidentified network - No internet". This is the 6X appearing as a network device.
In a web browser (no internet required) type 192.168.42.1 into the address bar and press enter.
If the sensor is being powered by the AC adapter the screen will appear red with a warning message.
The software update process begins and may take several minutes. Do not turn off the power or disconnect the cable during this process. It may reboot several times during the process.
Once complete, the web page will refresh. You can check the firmware version after the web page refreshes by checking the 'Current Version' at the top of the update page, or the version in the lower left of the web page menu bar.
