DJI Inspire 1 & 2
6X Series Sensors Installation - DJI Inspire 1 & 2
Last updated
6X Series Sensors Installation - DJI Inspire 1 & 2
Last updated
Sentera 6X Series Sensors
6X Product PagePurchase 6X MultispectralPurchase 6X ThermalPurchase 6X Thermal ProSentera Calibrated Reflectance Panel
Purchase Reflectance PanelInstall light sensor/GPS into mounting tray.
Connect the 90 degree adapter to the straight end of the USB-C cable.
Connect USB-C cable into light sensor.
Secure USB-C Cable.
Install 6X gimbal into Skyport.
Connect USB-C cable to gimbal.
Power On the aircraft.
The light sensor is connected to the USB-C port on the upper portion of the gimbal not the USB-C port on the sensor itself.
If a light sensor is not bring used, simply omit the related steps.
If a Light Sensor/GPS was purchased with the 6X, the hardware to mount to the drone needs to be installed. See the instructions linked below.
DJI Inspire 1 & 2