DJI Inspire 1 & 2

6X Series Sensors - Incident Light Sensor Installation - DJI Inspire 1 & 2

Light Sensor/GPS Mount

1. Remove the 2 screws shown using a 2.5mm hex driver.

2. Place mounting bracket onto the aircraft as shown.

3. Reinstall the screws.

4. Clean the top of the mounting bracket with an alcohol wipe and let dry.

5. Remove the adhesive backing from the mounting tray and place onto the mounting bracket as shown. Press firmly into place.

6. Use the alcohol wipe to clean the side of the aircraft and let dry.

7. Remove the adhesive back of the cable clip and attach to the side of the aircraft as shown. Press firmly into place.

Install the equipment in the shown orientation. This allows the light sensor, cable, and gimbal to be connected safely and effectively.