DJI M200/M210
6X Series Sensors Installation - DJI M200/210
Last updated
6X Series Sensors Installation - DJI M200/210
Last updated
Sentera 6X Series Sensors
6X Product PagePurchase 6X MultispectralPurchase 6X ThermalPurchase 6X Thermal ProSentera Calibrated Reflectance Panel
Purchase Reflectance PanelInstall light sensor/GPS into mounting tray.
Connect USB-C cable into light sensor.
Secure USB-C Cable.
Install 6X gimbal into Skyport.
Connect USB-C cable to gimbal.
Power On the aircraft.
The light sensor is connected to the USB-C port on the upper portion of the gimbal not the USB-C port on the sensor itself.
If a light sensor is not bring used, simply omit the related steps.
For dual gimbal mount setup the 6X should be placed in the correct port for the slected mode of operation (sensor configuration).
Use gimbal slot 1. This will power the sensor/gimbal/light sensor, and allow the sensor to communicate with the DJI autopilot and ingest trigger commands, GPS, altitude, and attitude information.
Use gimbal slot 2. This will power the sensor/gimbal/light sensor/external GPS. The 6X will use the light sensor/GPS module for GPS and altitude data, as well as allow the 6X to self trigger based on the auto-height overlap settings.
If a Light Sensor/GPS was purchased with the 6X, the hardware to mount to the drone needs to be installed. See the instructions linked below.
