DJI M200/210

6X Series Sensors - Incident Light Sensor Installation - DJI M200/210

Light Sensor/GPS Mount

1. Clean the top of the aircraft with an alcohol wipe and let dry.

2. Remove the adhesive backing from the mounting tray and place onto the mounting bracket as shown. Press firmly into place.

3. Use the alcohol wipe to clean the side of the aircraft and let dry.

4. Remove the adhesive back of the cable clip and attach to the side of the aircraft as shown. Press firmly into place.

Place the mounting tray in the shown location. Placing the mounting tray further towards the nose of the aircraft may block the internal aircraft GPS.

Install the equipment in the shown orientation. This allows the light sensor, cable, and gimbal to be connected safely and effectively.