Inspired Flight IF800

6X Series Sensors Installation - IF800

6X & Light Sensor

Instructions

1. Install light sensor/GPS into mounting tray.

2. Connect USB-C cable into light sensor.

3. Secure USB-C Cable.

4. Install 6X gimbal into smart dovetail.

5. Secure smart dovetail latch.

6. Connect USB-C cable to gimbal.

7. Power on the aircraft.

The light sensor is connected to the USB-C port on the upper portion of the gimbal not the USB-C port on the sensor itself.

If a light sensor is not bring used, simply omit the related steps.

Light Sensor/GPS Mounting

If a Light Sensor/GPS was purchased with the 6X, the hardware to mount to the drone needs to be installed. See the instructions linked below.

Inspired Flight IF800

---

Compatibility

If you have an IF800 that was not configured for Sentera sensors by Inspired Flight or Sentera, use the following instructions:

Inspired Flight Compatibility Settings - IF800 & IF1200