Inspired Flight IF800

6X Series Sensors - Incident Light Sensor Installation - IF800

Instructions

1. Use the provided screws to attach the mounting bracket to the aircraft.

2. Clean the mounting bracket surface with the provided alcohol wipes.

3. Remove the backing on the mounting tray and install onto the mounting bracket.

4. Use the alcohol wipe to clean the surface of the aircraft near the strobe.

5. Remove the backing on the cable clip and install onto the aircraft as shown.

The Case foam may need to be slightly modified to accommodate the cable clip.

The mounting bracket does not need to be removed to be stored in the case, but the light sensor itself does need to be removed from the mounting tray.