Standard Operating Procedure
6X Series Sensors Standard Operating Procedure Introduction
Last updated
Was this helpful?
6X Series Sensors Standard Operating Procedure Introduction
Last updated
Was this helpful?
The 6X can operate in two different modes. Each of these modes has a slightly different Standard Operating Procedure.
In this mode the 6X ingests triggering commands and GPS/Altitude/Attitude from the drone to capture and geotag imagery. This is the most common operational mode.
Supported Aircraft:
DJI M300/350
DJI M200/210
Freefly Astro
Inspired Flight IF800 & IF1200
In this mode the 6X uses GPS data from the light sensor/GPS module to determine when it should trigger the camera.
Operational mode and capture settings are selected using the configuration menu.
Advanced or custom configurations of the 6X may required a modified standard operating procedure.