How to Use
6X Series Sensors - Incident Light Sensor/External GPS How To Use Instructions
Last updated
6X Series Sensors - Incident Light Sensor/External GPS How To Use Instructions
Last updated
Sentera 6X Series Sensors
6X Product PagePurchase 6X MultispectralPurchase 6X ThermalPurchase 6X Thermal ProSentera Calibrated Reflectance Panel
Purchase Reflectance PanelIf a reflectance panel is also being used see the page linked below:
Install the light sensor and gimbal onto the aircraft.
Connect the USB-C cable to the light sensor.
Secure the cable to the aircraft.
Connect the USB-C cable to the port on the gimbal.
Power on the aircraft. This will also power the gimbal, sensor, and light sensor on.
Verify the Status LEDs shown below have all turned solid green.
The sensor and light sensor are now ready for flight.
For Gimballed Sensors
Connect the light sensor/GPS to the USB-C port on the gimbal
For Non-Gimballed Sensors
Connect the light sensor/GPS to the USB-C port on the 6X