DJI M200 & M210
Last updated
Was this helpful?
Last updated
Was this helpful?
Align the white dot on the gimbal connector with the red dot on the drone connector.
The turn until the red dot on the gimbal connector and drone connector align.
Power on aircraft.
For dual gimbal mount setup the 65R should be placed in the correct port for the selected mode of operation (sensor configuration).
Use gimbal slot 1. This will power the sensor/gimbal/light sensor, and allow the sensor to communicate with the DJI autopilot and ingest trigger commands, GPS, altitude, and attitude information.
Please see the page linked below for skyport compatibility information, such as supported skyport firmware versions.
