65R Sensor

Firmware

Verify the sensor firmware is up to date.

65R Firmware version 4.1.3 or greater is required for operation with the RTK-PPK module.

Firmware Update

---

Software Configuration

The 65R sensors require the proper software configuration to be selected for use with the RTK-PPK module. This tells the sensor which aircraft the sensor is flying on, which GPS information to use, and to log the proper data.

Use either of the following based on your aircraft model:

• IF800 - Sentera GNSS

• IF1200 - Sentera GNSS

Using the proper aircraft model is important because this information is used to compute the antenna offset

How To Change Sensor Configuration

Learn how to access the user interface and change the configuration file here:

How To Change Configuration

If the sensor configuration is not set to the correct aircraft model and configuration the RTK-PPK system will not function properly.

When using the Sentera GNSS configurations, the RTK-PPK module is required to initialize the sensor. Without the RTK-PPK module, the sensor will not get green LED indicator lights, and will not be ready to capture data.

If you intend to do non-RTK-PPK flights with the sensor, either change the config to the non-Sentera GNSS version, or fly with the module as normal.

---

Inspired Flight Compatibility Settings (LEGACY)

Inspired Flight aircraft automatically detect Sentera payloads and apply the necessary parameter changes.

IGC v1.3 or greater is required for automatic payload detection. Use the compatibility settings linked below if using older versions of IGC.

Inspired Flight Compatibility Settings

---

Sensor Installation

Install the sensor as described in the 65R User Guide:

IF800 Tomcat