Inspired Ground Control includes an NTRIP Widget that simplifies the process of streaming corrections to your Sentera Sensor. This NTRIP client allows for the connection to CORs/VRS networks.
Setup
1
Power Hand Controller
Assemble and power on the hand controller per manufacturer instruction.
2
Connect to Hotspot
Connect your hand controller to an internet hotspot. This is required to stream NTRIP corrections.
3
Open the NTRIP Widget
Click to open the NTRIP widget in Inspired Ground Control
Click 'Edit' to configure. If you have already entered your NTRIP information, click 'Connect' to start streaming.
4
Configure NTRIP Widget
For first time set up or if the network provider is changing the following steps must be completed
Enter the Server Address and Port
Enter your MountPoint, or press the Search Icon to see available Mount Points.
Click a Mount Point from the table to select it.
Enter your username and password.
Select Sentera from the Data Forward Preset dropdown menu.
5
Connect to Network
Click connect to start streaming. Enable "Connect On Start" to begin NTRIP streaming automatically.
Once connected, the NTRIP widget is green. Click on the widget to edit configuration information or disconnect.
6
Verify Session Start & Fix Type
Wait for the sensor to boot and start a session. The session start on the sensor is indicated by the LEDs on the sensor being solid green.
Verify the GPS fix type using the external LED on the module or use the camera indicator icon in the upper right-hand corner of IGC.
