SD Cards
Photo Capture Requirements
Last updated
Photo Capture Requirements
Last updated
Not all SD cards are equal.
You must use quality SD cards to maintain a high capture rate on any camera.
Most cameras and applications require a minimum of class 3 (U3 ~ 100mb/s) card or better.
Not all brands of SD cards are the same, even with the advertised class ratings. If you have problems with a specific manufacturer, try a more reputable maker for your next drone flight.
You can use the tool below to format SD cards for Sentera cameras.
All SD Cards used in Sentera cameras must be formatted in FAT32.
Sentera Single must have a card with a capacity of less than or equal to 32GB.
Sentera Double 4K must have a card with a capacity of less than or equal to 64GB.
If you exceed the capacity requirements above, the camera will fail to boot or take photos correctly.
If your card is too big, it will not work.
If the card is not formatted in FAT32, it will not work.
SD cards that are used in DJI cameras should be formatted using their companion app.
DJI GO 4
DJI Pilot 2
For more information about your drone and camera, please refer to your owner's manual, which can be found on DJI's Official Support Page.
Most DJI cameras do not support a capture rate of greater than 1000ms.
The Mavic 2 Pro typically requires 2 seconds or more between photo captures.
Please plan your flight accordingly. If you see skipped photos, then refer to this FAQ.
