Sentera Sensors & Drones6X Product PagePurchase Reflectance Panel

Accessing the Web User Interface on The Freefly Hand Controller

The Web User Interface for the 6X Sensor can be reach via the Freefly Hand Controller. The Web User Interface can be used to check the status, change settings and manually trigger the sensor.

1

Power on Drone and Hand Controller

2

Navigate to the Home Page on your Hand Controller

3

Open the Application Menu

Click the grid icon in the lower right hand corner to open the Application Menu.

4

Open the Web Browser Application

Click the Chrome Icon to open a webpage.

5

Enter The Sensor's IP Address in the browser

To navigate to the Web User Interface, enter the IP address listed below, then press go.

192.168.144.141
6

Web User Interface

From the home page you can check the status of the sensor, manually capture images, or navigate to other pages from the left hand side bar.

PreviousAccessing the Web User Interface on The Inspired Flight Hand ControllerNextHome

Last updated

Was this helpful?