Parameter Setup

Power On the Aircraft and Hand Controller

Power the aircraft and hand controller on.

Open AMC

Open AMC and verify the aircraft and hand controller are connected to each other.

Enter Advanced Mode

Repeatedly tap the Auterion logo in the upper left hand corner until the advanced mode pop up appears. Select Switch to Advanced.

Open the Advanced Menu

Press the Auterion Logo in the upper left hand corner to open the menu, then select the Advanced tab.

Open Parameter Menu

Scroll down in the left hand menu and select Parameters.

Serach for MAV_2_MODE

In the search bar at the top of the menu search for "MAV_2_MODE".

Change from GIMBAL to NORMAL

Tap on the parameter and a menu will appear on the right hand side of the screen. In the drop down menu select Normal and press Save.

Power Off Aircraft

To apply the changes the aircraft needs to be rebooted. Power the aircraft off.

Install Sensor and Power On Aircraft

Install the 6X Sensor and power the aircraft & hand controller on.

Astro | Sentera 6X Series Sensorssupport.senterasensors.com

Disable Advanced Mode

Repeatedly tap the Auterion logo in the upper left hand corner until the Normal mode pop up appears. Select Switch to Normal.

Or restart app/hand controller to switch back to normal mode.

Verify Functionality

Allow the aircraft and sensor to fully boot. Once the aircraft has achieved a 3D satellite fix the sensor will start a session and the light on the sensor will turn green.

Other functionalities that can be checked:

• Gimbal Steering: Use the rocker wheel on the left side of the controller to change the pitch angle of the gimbal

• Camera Triggering: Use the physical image capture button to test the image capture. The lights on the camera will flash white. This can also be done with the on screen button in the video window.