Inspired Flight IF1200A
6X Series Sensors Installation - IF1200A
Last updated
6X Series Sensors Installation - IF1200A
Last updated
Sentera 6X Series Sensors
6X Product PagePurchase 6X MultispectralPurchase 6X ThermalPurchase 6X Thermal ProSentera Calibrated Reflectance Panel
Purchase Reflectance PanelInstall light sensor/GPS into mounting tray.
Connect USB-C cable into light sensor.
Secure USB-C Cable using upper cable clip.
Secure USB-C Cable using lower cable clip.
Install 6X gimbal into smart dovetail.
Secure smart dovetail latch.
Connect USB-C cable to gimbal.
Power on the aircraft.
The light sensor is connected to the USB-C port on the upper portion of the gimbal not the USB-C port on the sensor itself.
If a light sensor is not bring used, simply omit the related steps.
If a Light Sensor/GPS was purchased with the 6X, the hardware to mount to the drone needs to be installed. See the instructions linked below.
Inspired Flight IF1200AIf you have an IF1200 that was not configured for Sentera sensors by Inspired Flight or Sentera, use the following instructions:
Inspired Flight Compatibility Settings - IF800 & IF1200