Freefly Compatibility Settings - Astro

Intro

Current Astro firmware and 6X firmware requires two parameters to be set for seamless operation. This requirement will be removed in an upcoming firmware release. Please use the page linked below for instructions on how to set the parameters.

Instructions

1. Power on Astro and hand controller & connect

2. Open AMC

   
3. Enter advanced mode by rapidly tap on the Auterion logo in the upper left hand corner until a dialog box appears.

   

   
4. Press Switch to Advanced

   
5. Press the Auterion logo in the upper left hand corner and press Advanced

   

   
6. Scroll down to Parameters on the left hand menu

   
7. In the search bar search "baud"

   
8. Change SER_EXT2_BAUD to 115200 8N1 and press Save

   
9. In the search bar search "MAV"

   
10. Change the MAV_2_MODE from GIMBAL to Normal and press Save

    

    
11. Turn the aircraft off

12. Connect the sensor to the aircraft

13. Power on aircraft

14. Restart AMC

15. Verify the lights on the 6X turn solid green